Your shopping cart is empty!
0 reviews / Write a review
Battery Temperature Sensor Cable for Inverter BTS
This Battery Temperature Sensor is for the Inverter Charger models with BTS port.
A Battery Temperature Sensor has been provided as a separate accessory.
It comes with 32.8’/10m cable and is recommended to be mounted on the
battery body or rack.
It allows precise monitoring and control of the charging voltage for optimum battery performance and longevity.
The ideal charge voltage required by batteries changes with battery temperature.
The battery temperature sensor allows the charge controller to
continuously adjust charge voltage based on actual battery temperature.
Temperature compensation of charge voltage assures that the battery
receives the proper charge voltage as battery temperature varies.
The entire line are equipped with Battery Temperature Sensing for increased charging precision.
It sends precise information to the charger, which automatically adjusts
voltage to help ensure full battery charge depending on the ambient
temperature of your battery installation.
When the battery voltage is over 40℃(104℉), it will reduce the charging voltage by 0.1Vdc with every degree of temperature rise.
We recommend that you install Battery Temperature Sensors on all banks
to protect your batteries and to provide optimal charging of each bank.
The battery temperature sensor mounts on the side of a battery or any
other location where the precise temperature of battery can be detected
such as battery mounting racks.
The following table describes approximately how much the voltage may vary depending on the temperature of the batteries.
In Charger Mode
BTS ≥ 50℃(122℉) Automatically turns off charger
BTS ≤ 40℃(104℉) Automatically turns on charger
In Inverter Mode
40℃(104℉) ≤ BTS ≤ 50℃(122℉) Increases the low voltage shut down point by 0.5Vdc
BTS ≥ 50℃(122℉) Over Temp Fault
Copyright © 2023 SolarGeni and or Wes That Tech Guy - All Rights Reserved. Designed by: Bitline.com